Special Pulse Generator Solutions


Ecopuls

Offers a less powerful but reasonably priced solution for plasma immersion applications.
Datasheet Ecopuls4 (german)


Ignitronpuls und Ignitronpuls 2

Device to control ignitrons or other applications where high current pulses with low repetition rate are needed.
Ignitronpuls holds 4 channels ans is available as OEM board or with housing.
Ignitronpuls 2 holds just 2 channels and is only available as OEM board.
Datasheet - Ignitronpuls       Datasheet - Ignitronpuls2 (german)


Hydropuls 2Hydropuls 2

Offers extreme powerful pulses (up to 30 kV, 500 A, 200 nF pulse capacitor) at up to 100 Hz, for treatment of fluids such as sterilization etc.
Datasheet


Hydropuls Mini

A less powerful but economic and smaller alternative for the Hydropulse 2.
Datasheet


RUPmag

RUPmag is a smaller pulse generator for magnetron sputter applications. It allows Frequencies up to 20 kHz, voltages up to 800V, power up to 1kW.
Datasheet


RUPmag2RUPmag 2

Versatile device for magnetron sputtering applications with two unipolar or alternatively one bipolar output. (800 V, 1 kW)
Datasheet (german)


RUPmag3RUPmag 3

Dual power supply unit for pulsed magnetron sputtering with low power (2*100 W) but high frequencies (up to 200 kHz).
Datasheet (german)


RUPmag 4

RUPmag 4 provides frequences up to 20 kHz, voltages up to 1 kV and 3 kW range of power for 2 channels.
Datasheet


MagnetronpulsMagnetronpuls

Provides the pulsed and current controlled high voltage power supply for a microwave magnetron.
Datasheet (german)


Magnetronpuls 4

Provides very short (100ns) but powerful pulses. Voltages up to 20 kV are adjustable.
Datasheet (german)


HFPuls 3HFPuls 3

Device delivers up to 40 kV at 1MHz, operation in burst mode with up 5 % duty cycle. Gadget for barrier discharches and other surface discharges with extreme requirements.
Datasheet


Minipuls

Minipuls 2 bridge and Minipuls 4 transistor cascade

Series of generators delivering high voltages with frequencies in the range 5-20 kHz through cascaded transformers. It is to put the device in an intermitted cw-operation. The average power ranges between 30 W up to 600 W depending on the edition. OEM boards will be delivered.
  • Minipuls 0: weight optimized edition with trigger, range of power up to 30 W
  • Minipuls 1: provides up to 20 kVss with frequencies in the range 5-20 kHz, external control, Burst and arbitrary modes are principially possible. Appropriate for dielectric barrier discharge applications
  • Minipuls 2: identical to the Minipuls 1, but delivers higher power output (120 W) and impedance adaption.
  • Minipuls 4: increased performance 300 W 40 kVss
  • Minipuls 6: increased performance 600 W 60 kVss

Datasheet - Minipuls0       Datasheet - Minipuls2 (german)
Datasheet - Minipuls4       Datasheet - Minipuls6



Nanopuls NPG-15/2000Nanopuls

The NPG-15/2000 generator is designed for barrier and other type discharge systems as well as others applications which requires high voltage power nanosecond pulses.
The NPG-15/2000 is not produced by GBS.
Datasheet


Specialpuls-9-12

Delivers an output voltage of ut to -12 kV.  25 % of that output voltage are pulsed. Appropriate for electrostatic applications.
Datasheet


Specialpuls 10x3

The pulse generator Specialpuls 10x3 is a triple switch for static high voltage. It is triggered by a TTL-Signal and is created for use in ionic optics.
Datasheet (german)


Multphasbatt

Device for plasma-aerodynamic experiments, delivers up to 10 kV with frequencies in the range 5-20 kHz, 4 syncronouos outputs with different phases. Available as OEM board.
Datenblatt (german)